Residential Concrete Wall Thickness

For plain concrete walls which are walls without or with little reinforcement 7 1 2 inch thickness is adequate.

Residential concrete wall thickness.

Concrete foundation walls with corbels brackets or other projections built into the wall for support of masonry veneer or other purposes are not within the scope of the tables in this section. Exterior wall thickness depends on siding material. The thickness of interior walls is dictated by stud width and wall covering. The thickness or depth of concrete basement walls plays an integral role in their long term strength and durability.

So taller walls in heavier soils should be made thicker or with stronger concrete. The appropriate depth of the wall depends on several factors and there is no single standard for every home. Concrete foundation walls support the home standing above so any weakness can undermine the stability of the house. The minimum thickness is also determined by wall height soil classification and the height of unbalanced backfill or backfill on only one side of the wall.

Where a concrete foundation wall is reduced in thickness to provide a shelf. 2 by 6 studs are typically used in walls that contain plumbing making those walls 6 5 inches. The thickness of bearing masonry wall of in residential building with maximum three storeys can be assumed to be 203 2mm 8 inch. Increasing the strength of the concrete mix or the thickness of the wall increases the wall s capacity.

The thickness of concrete foundation walls shall be equal to or greater than the thickness of the wall in the story above. The recommended maximum is 12 inches. Table 4a is based directly on the aci method but for table 4b the author has applied a reduced strength reduction factor a factor of safety. As soon as you go higher or have greater depths of soil pushing against the wall you need to increase the thickness to 10 inches.

Standard 2 by 4 studs are 3 1 2 inches wide and drywall is 1 2 inch thick so interior walls are usually 4 1 2 inches thick. The typical interior wall thickness in newer construction using 2 by 4 studs and half inch drywall is 4 5 inches. The 4 100 mm form cannot be used below grade as a foundation wall. The wall should not experience lateral loads and its height should not exceed 3 65m 12 ft otherwise such thickness cannot be considered.

The 4 100 mm form may be used for above grade walls up to a maximum of 10 3 0 m. Poured concrete foundation walls that are less than 8 feet tall and have soil outside that is 6 or 7 feet deep against the wall can often be 8 inches thick and function quite well.