Repair Split Wood Siding

Push up on the bottom edge of the siding to close the split and wipe off the excess glue.

Repair split wood siding.

Over time the siding can loosen in places or develop horizontal cracks in. Clapboard is a throwback to an earlier time when hemlock pine spruce or cedar boards were split lengthwise to produce siding. Repair methods for clapboard siding. To stop splits when nailing wood siding blunt the sharp end of the nail with a hammer.

You usually don t even need to re nail the split piece of wood but if you choose to nail the split piece of wood only nail about a 1 4 inch above the split. The slices were then nailed. The part of a board most likely to rot or decay is the end grain. Finally you can tack nail a 1 by 2 to the sidewall to hold the split closed until the glue dries.

Any natural wood siding is susceptible to damage from sun and rain. To avoid splits fix boards with a single nail at each stud and always drill pilot holes. Protect sound siding with a scrap piece of 1 4 in. After you remove the rotted courses use a small hacksaw to cut any protruding nail shanks or if you have a very strong grip use a good pair of wire cutters.

Before the siding can go up 1x4 starter strips of treated lumber should be nailed to the sill where the lower most course of siding will go up image 2. How to fix warped wood board siding if board siding is butted together too tightly during installation it may warp when moisture changes cause it to expand. To learn how to repair wood siding remove rotted boards with a flat pry bar. Wood cleaner can be used to remove sun damaged wood fiber.

The most important step of any wood siding repair is the final process of weatherproofing the repair area with paint or another type of sealant and caulk. Repairing wood siding is integral to owning a home with wood siding. How to fix cracked siding before painting. Wood can split or check.

Smaller defects in vertical wood siding can be filled with wood putty while severely damaged siding boards may need to be removed and. You can try pulling a warped board so that it s flat and tight by driving a couple of long galvanized screws through the siding into studs drill pilot holes to avoid splitting the siding. Measure the depth to make sure it is consistent with the existing courses above. Though wood siding is very strong a sufficient physical impact can split and crack it.

This won t work at the ends of boards so always drill pilot holes first.