Removing Mold From Attic Insulation

Installing fans in your attic windows so they blow outside helps reduce the airborne spores.

Removing mold from attic insulation.

This solution can cause discoloration on some surfaces so be cautious. If your attic mold is limited to a very small area you may be able to use a power sander or a wire brush to remove it. In these cases the mildicide treatment applied to the roof sheathing will also treat the mold on the insulation. Wear disposable clothing if possible.

By far the most popular diy mold killer is bleach. While wearing a mask and gloves to protect yourself from both the mold and the bleach carefully apply the bleach solution to the moldy area. You can also cover the insulation with plastic foil and fold the foil sealing its contents after the cleaning process. Mix a cup of bleach into a gallon of water and use that solution to attack the mold.

Remove all contaminated material seal it in plastic and dispose of as regular waste. Therefore in some cases it is best to remove the affected insulation. Put on protective gear before touching moldy insulation. Cardboard paper or loose fill insulation should be disposed of as these will be practically impossible to clean.

The epa and other government agencies no longer recommend bleach for doing this. The most effective way to remove mold from hard porous materials such as wood rafters and plywood roof decking is to scrub it with detergent and water while wearing a dust mask and rubber gloves. Lay dropcloths on the floor taping the edges to the wall. Because wood is porous it may be difficult to remove the mold stains from sheathing but you can kill.

How to remove moldy insulation 1. Wet insulation should be removed as quickly as possible and allowed to dry. The mold removal process involves scrubbing hard surfaces with a biocide but porous items like insulation and drywall cannot be cleaned and must be thrown out and replaced. Bleach is corrosive and nasty to use and it kills only surface mold.

Wooden wall studs and similar items must often be sanded to remove all traces of mold since wood is somewhat porous. Brush all contaminated porous insulation such as fabric or foam with a wire brush to remove loose mold. They recommend using hepa vacuum after this but in the attic you d most likely have to remove the floor insulation if contaminated. This will not remove the mold spores or the discoloration.

In most cases mold growth on the insulation is found when mold on the roof sheathing is present as well. If not wear coveralls. Tape the seams as well to prevent mold spores from.