Removing Kitchen Faucet Mounting Nuts

After removing the nuts you can wiggle the kitchen faucet from the sink.

Removing kitchen faucet mounting nuts.

A special tool called a basin wrench can make removing the mounting nuts easier. Depending on the faucet style there may be two such mounting nuts or only one. They have been in the moist confines of the sink cabinet for years and mineral deposits have had all that time to collect in the threads. A bottom mount faucet uses a design in which the bulk of the faucet body is found below the sink.

When these mounting nuts are removed the faucet body can be dropped down and removed from. A basin wrench has a pivoting gripping head that sits at the end of a long handle and it is designed to reach up into that awkward inaccessible space behind a sink to tighten or loosen the mounting nuts on a faucet or the flexible supply tube nuts that connect to the end of the faucet tailpieces. The easy way to access a corroded basin faucet fixing nut for removal. Clean the sink before you install a new kitchen faucet.

Slide the open end of the faucet wrench over the supply tube and push it up to the faucet nuts. Remove faucet nuts with a faucet wrench. Remove the nuts by turning them counterclockwise. In addition remove the caulking or putty from the sink surface by using the putty knife.

Remove the old kitchen faucet. Here you ll need to remove the handles and spout then loosen and remove the mounting nuts holding the faucet from above. Take the faucet out and clean the place where the faucet sat. Removing an old kitchen faucet is simply a matter of disconnecting the faucets hot and cold water supply lines and unscrewing the nuts that hold the faucet in place.

Remove and reattach the ratchet handle as you rotate the nut. как открутить гайку кухонного крана если она прикипела намертво. The stroke by billy squier permission to use in this video by the legend hims. This guide will demonstrate the few easy steps necessary to remove an old faucet in preparation for the installation of a new one.

The most difficult part of replacing a faucet is removing the old one and that s because the nuts holding it to the countertop or sink deck are invariably stuck and for good reason. Then turn the ratchet and it will self center on the nut. Reaching these nuts can be difficult because of their cramped location between the back of the sink and the wall of the base cabinet.