Remote Control Ceiling Fan Light Wont Turn Off

Replace the ceiling fan capacitor.

Remote control ceiling fan light wont turn off.

If you want to reset the remote. Hunter fan remote reset follows the same steps making the troubleshooting easy. Open the battery cover of your remote control under the battery will be a set of dip switches match the dip switch code from your old remote to the new remote test to see if the lights can be turned off. The first step is to see if the remote was faulty.

For 10 seconds hold down the off button. Reset the remote of your fan. The fan is on and won t turn off. Once complete return the battery and cover the remote.

When i turn the power back on the fan goes back on. To determine the cause of the fan speed malfunction follow the steps below. Turn off the ceiling fan using the remote. I hope this helps.

Wait for 30 seconds before turning the fan on again. Run the ceiling fan for a few minutes. You will also find a corresponding set of dipswitches on the fan. Change the switch setting to match the settings of the hand held remote control.

But if you have a unit that has both a light and a fan the wall switch will usually turn off both of them. If the above does not resolve the issue continue to the following steps to check for over heating. If the fan sometimes turns on by itself off by itself or the light kit does this on it s own then this is a good sign you do need to change the dipswitches. Dipswitches are toggle switches on the back of the remote.

If your ceiling fan won t turn on or your speed settings are not working properly you may notice a sharp change in the airflow. Turn off the ceiling fan and allow the blades to come to a full stop. Typical ceiling fan remote control modules are located above the ceiling fan support bracket in the ceiling. It is controlled by a remote control only no switch.

The process will change the frequency settings and allow the remote to work again. If you want to stop the fan but still use the light you have to use the pull cord or the remote. One of the wires from the ceiling should be capped off usually the red one. Turn on the power from the mains.

Clean and lubricate the ball bearings. I tried replacing the battery for the remote already and i tried turning off the power to the house. You can use that to turn the fan on and off. The remote module has a set of small dip switches on the side of the module.

The bad news is the fan canopy must be dropped to access the receiver. Resetting your remote setting is easy and it only takes a few easy steps. Typically there is also a wall switch. However the light on the fan works and the remote does control the light.

If the lights are still stuck on at this point it is time to replace the receiver. Reset the fan remote. Turn of your fan using its dedicated remote control. This will sync the ceiling fan remote with the receiver.